WARNING
A LICENSED ELECTRICIAN SHOULD PERFORM INSTALLATIONIN ACCORDANCE
WITH THE NATIONAL ELECTRIC CODE (NEC) AND RELEVANT LOCAL CODES.
DISCONNECT MAIN POWER AT THE SOURCE PRIOR TO INSTALLATION.
INSTRUCTIONS MEANT FOR A REMOTE CLASS 2 DRIVER.
Canopy
Set screw
Cover plate
1/8" IPS x 1" length
threaded nipple
Top cap
1/8" IPS nut
1/8" IPS nut
Set screw
FIGURE 5
Bottom cap
Power cord
from fixture
Canopy
Cap screw
Set screw
POWER FEED OPTIONS
STEP 1A: JUNCTION BOX COVER PLATE INSTALLATION INSTRUCTIONS
FIGURE 1
FIGURE 2
CEILING MOUNTED
FOR FIXTURE MOUNTED DIRECTLY TO
THE CEILING.
SEE
STEP 1B
FOR DETAILED
INSTALLATION AND WIRING
INFORMATION.
JUNCTION BOX MOUNTED
FOR FIXTURES WIRED TO A JUNCTION
BOX.
SEE
STEP 1A
FOR DETAILED INSTALLATION
AND WIRING INFORMATION.
1
2
3
4
Pass low voltage wires from junction box through cross bar and
through 1/8" IPS x 1" length threaded nipple attached to cover
plate as shown. Screw 1/8" IPS into the crossbar to connect cover
plate to crossbar.
FIGURE 3
Attach the crossbar to the junction box using provided screws.
FIGURE 4
Loosen cap screw in bottom cap to release the bottom cap.
Pass power cord from fixture through the cap and canopy as
shown. Adjust the length of power cord to adjust fixture's drop
height. Tighten set screw after adjusting power cord length.
Attach bottom cap by tightening the cap screw.
Make sure bottom cap and canopy are aligned properly
before securing cap screw.
FIGURE 6
Remove set screws from canopy to release top cap.
Install cover plate on the top cap as shown.
FLUTES LYDIAN PENDANT INSTALLATION GUIDE
2
WWW.JUNIPER-DESIGN.COM | [email protected] | +1 347 799-2915 | 157 WATER STREET SOUTHINGTON, CT 06489
