Juniper EX4500 Series, Руководство по оборудованию, Страница: 92 / 327

Console Port Connector Pinout Information
The console port on a Juniper Networks device is an RS-232 serial interface that uses an RJ-45 connector
to connect to a console management device. The default baud rate for the console port is 9600 baud.
Table 28 on page 92 provides the pinout information for the RJ-45 console connector.
NOTE: If your laptop or desktop PC does not have a DB-9 plug connector pin and you want to
connect your laptop or desktop PC directly to a device, use a combination of the RJ-45 to DB-9
socket adapter and a USB to DB-9 plug adapter. You must provide the USB to DB-9 plug adapter.
Table 28: Console Port Connector Pinout Information
Description Signal Pin
Request to send RTS Output 1
Data terminal ready DTR Output 2
Transmit data TxD Output 3
Signal ground Signal Ground 4
Signal ground Signal Ground 5
Receive data RxD Input 6
Data carrier detect CD Input 7
CTS Input NC 8
USB Port Specifications for an EX Series Switch
The following Juniper Networks USB flash drives have been tested and are officially supported for the
USB port on all EX Series switches:
•
RE-USB-1G-S
•
RE-USB-2G-S
•
RE-USB-4G-S
92