Juniper EX3300, Руководство по оборудованию, Страница: 141 / 272

•
Mounting an EX3300 Switch on a Desk or Other Level Surface on page 119
•
Mounting an EX3300 Switch on a Wall on page 126
•
Connecting Earth Ground to an EX Series Switch on page 131
Mounting an EX3300 Switch on a Desk or Other Level Surface
You can mount an EX3300 switch on a desk or other level surface by using the four rubber
feet that are shipped with the switch. The rubber feet stabilize the chassis.
Before mounting the switch on a desk or other level surface:
• Verify that the site meets the requirements described in “Site Preparation Checklist
for EX3300 Switches” on page 51 .
•
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
• Read “General Safety Guidelines and Warnings” on page 199 , with particular attention
to Chassis Lifting Guidelines for EX3300 Switches .
Ensure that you have the following parts and tools available:
• 4 rubber feet to stabilize the chassis on the a desk or other level surface (provided in
the accessory box in the switch carton)
To mount a switch on a desk or other level surface:
1.
Remove the switch from the shipping carton (see “Unpacking an EX3300 Switch” on
page 113 ).
2.
Turn the chassis upside down on the desk or the level surface where you intend to
mount the switch.
3.
Attach the rubber feet to the bottom of the chassis, as shown in Figure 22 on page 119 .
4.
Turn the chassis right side up on the desk or the level surface.
Figure 22: Attaching Rubber Feet to a Switch Chassis
g021208
Rubber feet
119 Copyright © 2016, Juniper Networks, Inc.
Chapter 12: Installing the Switch