Juniper EX2200 Series, Руководство по оборудованию, Страница: 79 / 214

Figure 28: Mounting the Switch to the Front Posts of a Rack
g004477
8.
Have a second person secure the front of the switch to the rack by using the appropriate
screws for your rack.
9.
Slide the rear mounting-blades into the side mounting-rails. See Figure 29 on page 79 .
Figure 29: Sliding the Rear Mounting-Blades into the Side Mounting-Rail
g004478
10.
Attach the rear mounting-blades to the rear post by using the appropriate screws for
your rack. Tighten the screws.
11.
Ensure that the switch chassis is level by verifying that all the screws on the front of
the rack are aligned with the screws at the back of the rack.
Mounting an EX2200 Switch in a Recessed Position in a Rack or Cabinet
You can mount an EX2200 switch except the EX2200-C switch model in a rack or cabinet
such that the switch is recessed inside the rack from the rack front by 2 inches. You can
use the 2-in.-recess front brackets provided in the separately orderable four-post
rack-mount kit to mount the switch in a recessed position.
Reasons that you might want to mount the switch in a recessed position include:
•
You are mounting the switch in a cabinet and the cabinet doors will not close completely
unless the switch is recessed.
• The switch you are mounting has transceivers installed in the uplink ports—the
transceivers in the uplink ports protrude from the front of the switch.
79 Copyright © 2018, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration