Juniper CTP1000 Series, Руководство по оборудованию

Страница: 60 / 88

•
Ground wires—We recommend a minimum of 18-AWG ground wire for AC and
DC-powered versions, if applicable.
• Two #10 kep nuts (supplied) to connect the ground (earth) wire to the ground terminal.
•
Power module wiring—We recommend a minimum of 18-AWG wire for the device with
a dual stud terminal lug with 5/8-inch spacing.
Consider the distance from the connection point and the configuration of the device
when determining the size of wire used.
Table 9: Required Cables
Port and Cable Used Connection
One 10/100Base-T Ethernet management port
with an RJ-45 connector. Management connection between the processor
module and the LAN
One RS-232 port with a DB-9 connector for
VT100 management access. Management connection between the processor
module and a management console
Cables vary depending on module. Direct connections to interface modules
Related
Documentation
Cabling the CTP1000 Platform Overview on page 49
•
CTP Fast Ethernet and Power Cables
• Fast Ethernet Cables on page 50
•
DC Power Cables on page 50
Fast Ethernet Cables
The Ethernet connection is a standard RJ-45 connector. Typically, a straight-through
cable is used to connect to a switch, and a crossover cable is used to connect to a router.
DC Power Cables
For CTP chassis with DC power options, we recommend 18-AWG power cables.
Copyright © 2015, Juniper Networks, Inc. 50
CTP1000 Series Hardware Guide