Resolved Issues
17
BXOS 4.1 R2 Software Release Notes
Any SNMP query to BX7000 should have minimum of 5 seconds as timeout to
get a valid response. [PR/500398]
When a transit link transitions to a stub and the router is a default router, traffic
loss upto a maximum of 0.5 seconds is observed. [PR/511582]
Resolved Issues
The
show interface
command displays output only for configured interfaces. As
a workaround, use the
show ports
command to display all ports in the gateway.
[PR/285104: This issue has been resolved.]
When you configure a SAToP pseudowire with circuit emulation source (CES)
as clock source on the T1 interface, the Valid8 test tool connected to the
gateway fails to detect the T1 link when it is in UP state and the pseudowire
does not send packets from TDM to PSN direction. As a workaround, use the
TDM stream analyzers such as GL TDM analyzer or Advanced Network Tester
(ANT-20)
to perform the SAToP pseudowire testing. [PR/315003: This issue has
been resolved.]
The CLI does not support a
delete
command to delete the SNMP protocol.
There is no workaround. [PR/388295: This issue has been resolved.]
The CLI does not support deleting the OAM configured on a TDM interface. As a
workaround, delete the subinterface and reconfigure the same with new OAM
configuration. [PR/388452: This issue has been resolved.]
When you create and delete multiple BA or MF classifiers, the gateway fails to
free the allocated memory completely. There is no workaround. [PR/398404:
This issue has been resolved.]
The
show arp
command displays wrong interface name for VLAN interfaces if
the unit ID and VLAN ID are different. This does not have impact on traffic or
system functioning. There is no workaround. [PR/402329: This issue has been
resolved.]
Packet scheduling does not work properly at full line-rate traffic on an Ethernet
interface. At full 1 Gigabit traffic comprised of 1500-byte packets, the system
sends out packets from low priority queues interleaved between high priority
traffic. There is no workaround. [PR/403717: This issue has been resolved.]
The
show ldp neighbor
command displays only one neighbor. There is no
workaround. [PR/414980: This issue has been resolved.]
After setting the OSPF interface type to point-to-point, if you disable and enable
the Ethernet interface, the OSPF interface type of that interface goes back to
LAN interface. As a workaround, disable the Ethernet interface and configure it
to point-to-point interface. [PR/417048: This issue has been resolved.]
Applying configuration from zero touch reboots the gateway. There is no
workaround. [PR/417906: This issue has been resolved.]
