Juniper BT8A78CH1, Обзор оборудования и руководство по установке

Страница: 69 / 228

CHAPTER 3
Unpacking the BTI7800 Series Shipment
• Unpacking the Equipment on page 69
• Verify Shipment Contents on page 70
•
Lifting and Moving the BTI7814 Chassis on page 70
Unpacking the Equipment
The number of packages and contents of your BTI7800 shipment is dependent on the
chassis platform and configuration, and the modules and pluggable transceivers that
you ordered. When unpacking the equipment, you should verify the contents against the
bill of sale, and visually inspect all the equipment to verify that it is not damaged. For
detailed information about the equipment, refer to the particular equipment topic. This
section describes general instructions for unpacking BTI7800 Series equipment.
When unpacking the BTI7800 equipment:
• Leave equipment packed until it is needed for immediate installation.
•
After unpacking the equipment, save and store the packaging material in case the
equipment must be returned.
• Inspect all sides of the chassis, looking for any signs of damages while shipping.
• Store the modules in their antistatic bags until you are ready to install them.
•
Handle the modules by the edges to avoid touching any pins, leads, or solder
connections on the circuit board.
If the packaging is damaged and possible equipment damage is present, preserve as
much of the packaging as possible and contact Juniper Networks Support.
1.
Open the top of the shipping container.
2.
Remove any information sheets and sub-packages.
3.
Carefully remove the protective packing material from the top of the chassis.
4.
Remove the packaging from the BTI7800 Series chassis.
The BTI7814 chassis ships boxed on a standard wooden pallet.
69 Copyright © 2019, Juniper Networks, Inc.