Jungheinrich ESE 533, Руководство по эксплуатации

Страница: 59 / 133

4 Industrial Truck Operation
4.1 Safety regulations for truck operation
Travel routes and work areas
Only use lanes and routes specifically designated for truck traffic. Unauthorised third
parties must stay away from work areas. Loads must only be stored in places
specially designated for this purpose.
The truck must only be operated in work areas with sufficient lighting to avoid danger
to personnel and materials. Additional equipment is necessary to operate the truck in
areas of insufficient lighting.
DANGER!
Do not exceed the permissible surface and point loading on the travel lanes.
At blind spots get a second person to assist.
The driver must ensure that the loading dock /dock leveller cannot be removed or
come loose during loading/unloading.
Travel conduct
The operator must adapt the travel speed to local conditions. The truck must be
driven at slow speed when negotiating bends or narrow passageways, when passing
through swing doors and at blind spots. The operator must always observe an
adequate braking distance between the forklift truck and the vehicle in front and
must be in control of the truck at all times. Abrupt stopping (except in emergencies),
rapid U turns and overtaking at dangerous or blind spots are not permitted. Do not
lean out or reach beyond the working and operating area.
Travel visibility
The operator must look in the direction of travel and must always have a clear view
of the route ahead. If the truck is carrying loads that affect visibility, the truck must
travel against the load direction. If this is not possible, a second person must walk
alongside the truck as a lookout to observe the travel route while maintaining eye
contact with the operator. Proceed only at walking pace and with particular care.
Stop the truck as soon as you lose eye contact.
Negotiating slopes and inclines
Negotiating slopes and inclines up to 10% ohne Last, 5% mit Last is only permitted
when they are recognised lanes. The slopes and inclines must be clean, have a non-
slip surface, and negotiating them safely must be within the technical specifications
of the truck. The truck must always be driven with the load facing uphill. The
industrial truck must not be turned, operated at an angle or parked on inclines or
slopes. Inclines must only be negotiated at slow speed, with the driver ready to
brake at any moment.
59
02.21 en-GB