KNX
Room Controller Universal
Ref.-no.: RCD 20xx
temperature drop detection • external controlled objects for comfort
mode, freeze and heat protection and control lock-out • control status, set
value and actual value through KNX/EIB accessible • set value
adjustment of max. ± 6 K through push button and software possible •
lock-out of the control elements to protect against unauthorised
adjustments
3. Installation
Attention! Electrical equipment must be installed and fitted only by
qualified electricians and in observance of the applicable accident
prevention regulations. Any non-observance of the fitting
instructions may cause fire or other hazards.
4. Connection and mounting of the RCD 20xx
The RCD has an integrated bus coupling unit. It is connected with a bus
terminal connection block (2).
•
1.Metal plate (1) to be mounted on one or two vertically arranged
wall boxes. When using only one box, the lower part has to be
screwed via the fixing holes (10).
•
Attach the frame (3) to the RCD.
•
Connect the bus terminal (2) at the back side.
•
Attach the RCD (4) and frame (3) on the metal plate (1). Notice:
Do not pen in the terminal wires.
•
Screw on the fixing screw (8).
•
Remove the protection foil (5) from the display.
•
Put on the transparent cover (7) with the inscription foil (6) to the
RCD.
The programming mode is activated by pushing the programming button
(9).
Note:
Do not mount the device next to heat sources due to the influence
of the integrated temperature sensor.
2