Jung J630D, Руководство пользователя

Страница: 65 / 316

J630D
4. Functional description of the operating modes 26.7.02 59
4.2 Setting-up mode
• Set the key switch to setting-up mode (32)..
Positioning the axes with the + and - keys
– Maximum feed rate (78.74 inch/min) in the X-axis.
– Up to 39.37 inch/min when positioning downwards (-) in the Y-axis.
– Up to 78.74 inch/min when positioning upwards (+) in the Y-axis.
– Up to 78.74 inch/min in the Z-axis.
– Maximum feed rate 19.69 inch/min in the U and W-axes (optional PA 31K
dresser).
– Maximum feed rate 39.37 inch/min in the E-axis (optional PA 31K dresser).
• Select the axis you want to position on the remote control panel.
• Press the + or - key to position the axis in the required direction.
Positioning the axes with the electronic handwheel
• Select the axis you want to position on the remote control panel.
• Select the infeed value per handwheel increment on the remote control panel
(4 = 0.00001 inch, 7 = 0.0001 inch or 9 = 0.001 inch). See section 3.3 “Remote
control panel” on page 55.
• Turn the electronic handwheel in the required direction (minus = anti-clockwi-
se, plus = clockwise).
Other conditions and restrictions
• You are allowed to set the actual values, but they are not updated on the dis-
play. You can only display the current actual values in automatic mode.
• Reciprocation in the X-axis is not possible.
• The grinding wheel can only be run at half the normal peripheral speed. If the
normal peripheral speed is greater than 114.8 ft/s, the maximum setting-up
speed is 55.77 ft/s.
The machine axes can be positioned in setting-up mode with the
remote control panel if the guard door is open.
The rapid traverse function is not available in setting-up mode.
The V and W-axes cannot be positioned using the electronic hand-
wheel.