Function
Rocker, Other modes, Unused
Basic setting: Rocker
Rocker
The channel works as a
channel button. Setting is
always made in pairs.
Other modes
The channel works as a scene
button. Setting is always made
in pairs.
Unused
The channel is not displayed
in the
eNet SMART HOME
app
and is disabled for use in
the commissioning interface.
Operating mode
App use, lock-out protection,
forced operation, wind alarm,
sun protection, twilight
Basic setting: App use
Setting the type of scene used
for a scene button. Setting is
always made in pairs.
Advanced settings
Parameter name
Setting options, Basic
setting
Explanations
Manual commissioning
On, Off
Basic setting: On
Disables manual
commissioning for all device
channels.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Extended channel settings
Parameter name
Setting options, Basic
setting
Explanations
Manual commissioning
On, Off
Basic setting: On
Blocks manual commissioning
for the device channel.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Local Operation
On, Off
Basic setting: On
Blocks the device channel for
local operation.
6.3 Troubleshooting
After a brief button-press, the transmission LED flashes.
Cause: battery in the wall transmitter is almost empty.
Change the battery (see chapter Insert battery).
Receiver does not react, transmission LED displays a transmission error. The
transmission LED flashes quickly for approx. 3 seconds.
Cause 1: Radio range exceeded. Structural obstacles reduce the range.
Using a radio repeater.
Cause 2: Actuator is not ready for operation.
Check the actuator and mains voltage.
Cause 3: There are radio faults, e.g. through outside radio.
Eliminate radio interference.
9/10
32595513
J0082595513
22.03.2017
eNet radio transmitter module
