EnOcean radio transmitter
05.03.2021
3 / 5
0024000901
Adhesive fixing
Important:
The final strength of the adhesive is only reached after 24 hours.
• After gluing the holder plate, let the adhesive cure a little.
Important:
The installation location cannot be changed after the adhesive fixing.
•
To test the range, carry out commissioning before adhesive fixing.
Prerequisite:
Surface is dry, clean, stable and even.
Suitable cleaning agents:
water, degreaser, glass cleaner, methylated spirit
Not suitable for cleaning:
Bath or all-purpose cleaner, aggressive detergents
•
Remove the protective film from the back of the adhesive pad (1).
• Stick the adhesive pad aligned on the surface.
Press firmly for about 10 seconds.
•
Remove the protective film (8) for the holder plate (2).
Do not remove the remaining protective films.
• Stick the holder plate onto the adhesive pad.
5 Operation
Fig. 5: Operation
Operating elements
The radio transmitter is operated either via one rocker (2-channel) or via two rockers (4-channel). There are four
push-buttons (9) under the rockers. The push-buttons are grouped into two channels (A and B). A distinction is made
between two states (I and O) for each channel.
The functions of the rockers (switching, push-button, dimming or blind) are not configured in the factory settings of the
device.
Factory settings/Reset
Restoring factory settings:
• Remove rockers (5) carefully with a suitable tool (e.g. button lever).
• Press all four push-buttons (9) and press the activation bar (10) simultaneously 7 x.
Factory settings are restored automatically.
The radio transmitter is no longer taught-in.
Rockers are without function.
• Snap rockers on again.
10
9
9
9
9
