Call up All Off
In the teaching procedure for a channel button or a light scene button, the All Off button of the
receiver is automatically also taught, with the exception of radio blind actuators.
Function switch 1 is in the
OFF
position (see Commissioning chapter).
o
Press button
1-
longer than 1 second.
The loads at all taught receivers are switched off.
5 Information for electrically skilled persons
5.1 Fitting and electrical connection
Connecting and mounting the device
Maintain a distance of at least 1 m between transmitter and receiver.
Maintain distance to large metal surfaces, e.g. metallic door frames.
i
Perform commissioning and teaching procedures before installation (see chapter
Commissioning).
o
Carefully remove inscription panel cover (5) and inscription panel (4) from the wall
transmitter (figure 1).
o
Slacken fastening screws (3).
o
Remove wall transmitter (1) from the base plate (2).
o
Inset battery if necessary (see section Changing the battery).
o
If necessary, set functions using function switch (see Commissioning chapter).
o
Glue or screw the base plate to an even surface (information on gluing mounting). The
TOP/OBEN
label has to be at the top.
o
Screw wall transmitter onto base plate.
o
Attach covers with labelling fields.
Information on gluing mounting
To be able to fasten the wall transmitter safely, the substrate must be flat and free of dust and
grease.
o
Remove the rear, unpunched film of the enclosed adhesive pad.
o
Align the adhesive pad, stick it to the surface and smooth it out. Remove air bubbles.
o
Remove the two inner segments of the front film.
o
Align the base plate to the external punching and stick it on.
i
In the case of multiple combinations, the abutting sides of the adhesive pads must be cut
along the external punching using a ruler and a cutter (figure 4).
4/8
32562723
J0082562723
21.07.2016
Radio Management
Flat wall-mounted radio transmitter
