Page 2
0024015020 12.10.2012
Information for electrically skilled persons
Installation and electrical connection
DANGER!
Electric shock from touching live parts in the installation environment.
An electric shock can be fatal.
Before working on the device, disconnect the power and cover live parts in the area!
Snapping on the adapter frame
An adapter frame is required depending on the switch range.
The adapter frame for the series LS is pre-mounted.
• Snap adapter frame (3) in the right orientation from the front onto the module (8) (Figure 2). Observe the label „TOP“.
Connection
Attention!
Connect the push-button sensor module exclusively to the universal stations.
Installing and connecting the device
(8)
(13)
(4)
(5)
(5)
(11)
(12)
(8)
(10)
(9)
Bild 2: Installation with expansion module
(9) Connecting cable TSEM
(10) Plug-in position
(11) Push-button sensor expansion module
(12) Frame
(13) Double supporting ring
Supporting ring side A for A range, CD range
and flat design.
Supporting ring side B for LS range.
When using the push-button sensor expansion module (Figure 2): vertical installation is preferred. Use the double supporting ring (13). For
installation to a flush-mounted box only, countersink the lower screws in the wall, e.g. with bore ø 6 x 10 mm. Use supporting ring as template.
DANGER!
When installing with 230 V devices under a common cover, e.g. socket outlets, there is a danger of electric shock in the event
of an error!
An electric shock can be fatal.
Do not install any 230 V devices in combination with a push-button sensor expansion module under a common cover!
• Install supporting ring (1) or (13) in the right orientation on an appliance box. Observe the label „TOP“; label A or B forwards.
Use only the supplied box screws (8).
• Insert frame (2) onto the supporting ring.
• Preferred installation position of push-button sensor expansion module (15) is below.
Guide connecting cable (16) between supporting ring and intermediate web.
• Push-button sensor expansion module: insert connecting cable (16) in the right orientation in the plug-in position (17) in the push-button
sensor module.
Do not pinch the connecting cable.
• Connect push-button sensor module (4) with connecting terminal (7) to the station and insert onto the supporting ring.
• Fasten the push-button sensor module(s) to the supporting ring using the enclosed plastic screws (5).
Only tighten the plastic screws lightly.
