Jumpking Orbounder 12ft Combo YJ, Руководство пользователя

Страница: 17 / 21

6. Using the included plastic tie, attach the Safety
Placard (11) to the frame near the point where
jumpers will climb onto and off the trampoline.
The trampoline is now fully assembled. Make
sure that all parts are securely attached.
Familiarize yourself and all users of the tram-
poline with the safety precautions, use and
instructional materials, and care and mainte-
nance instructions in this manual before using
the trampoline.
Loosen the straps (not shown) on the underside of
the frame pad (for clarity, the frame pad is not shown
in the steps 8 and 11). Do not remove the frame pad
from the trampoline.
See the inset drawing.
6
Frame
8. Lay a Straight Tube(16) and a Top Tube (17)
with Plastic Cap on the ground.
Make sure that the Straight Tube (16) is oriented
so the small holes are in the position shown.
Slide a Foam Sleeve (21) onto each of the tubes;
note that the ends of the Straight Tube (16) should
not be covered.
Insert the Straight Tube (16) into the Top tube(17).
Tighten a Self-tapping Screw (12) into the small hole
in the Tube (16,17).
Assemble the remaining Straight Tubes (16), Top
Tubes (17), and Foam Sleeves (21) in the same
way.
9.
7LJKWHQ6HOIWDSSLQJ6FUHZ
,QROH
6PDOO+ROH
3ODVWLF&DS
18
3ODVWLF&DS
8EROWV
6RFNHW
7.
Slide a ‘WEDGE’(23) onto the
Straight Tube(16), the top of the ‘Wedge’(23)
should touch the bottom of the T-Connector(4),
and that the bottom of the ‘Wedge’ (23) should
be even with the bottom of the straight tube.
Slide one of the U-bolts(15) up until it touches the
bottom of the T-connector(4), and tighten the two
Locknuts(13) on the U-bolt. Slide the other U-bolt
up until it is 2” above the lower end of the Straight
tube,and tighten the two Locknuts on the U-bolt.
Then, press two U-bolt Plastic Caps(24)
onto each U-bolt.
15
14
13
24
T-connector