Jumpking JumpPOD, Руководство пользователя

Страница: 18 / 22

7. Using the included plastic tie, attach the Safety
Placard (20) to the frame near the point where
jumpers will climb onto and off the trampoline.
The trampoline is now fully assembled. Make
sure that all parts are securely attached.
Familiarize yourself and all users of the tram-
poline with the safety precautions, use and
instructional materials, and care and mainte-
nance instructions in this manual before using
the trampoline.
7
Frame
8. Lay a Enclosure straight pole(13) and a
Enclosure top curve pole(14) with Plastic Cap
on the ground.
Make sure that the Enclosure Straight pole(13) is
oriented so the small holes are in the position shown.
Slide a Foam Sleeve(17) onto each of the tubes;
note that the ends of the Enclosure Straight pole(13)
should not be covered.
Insert the Enclosure Straight pole(13) into the
Enclosure Top curve pole(14).
Tighten a Self-tapping Screw (18) into the small hole
in the Tube (13,14).
Assemble the remaining Enclosure Straight pole(13),
Enclosure Top cuver pole(14) and Foam Sleeves (17)
in the same way.
8
9
9. Insert the end of Pole (13,14) into the hole of
POD-Connector(4).
Make sure that the Enclosure straight pole(14) are
oriented so the small holes are in the position shown.
Tighten a Self-tapping screw(18) into the small hole
in the POD-Connector(4).
Attach the other three Poles (13,14) in the same way.
See inset drawing.
Tighten Self-tapping Screw
Into Small Hole
Small Hole
Plastic Cap
(15)
20
13
14
18
13
18
18
17
17
17
17
Plastic Cap
(15)
13
14
4
10
9
Insert the Completed Pole(13,14)into
the hole of POD-Connector(4).
13
14
4