JUMO exTHERM-DR, Руководство по эксплуатации, Страница: 61 / 100

9 Configuration level 61
9.8 Service
Parameters Comment
Value range
(default setting in bold)
9.8.1 Limit switching opera-
tion Limit value for relay output controller K1
Here, the limit value for the admissible relay switching
operations is set.
If the counter value for Current switching operations
is greater than this value, the display values flash and
the relay output controller K1 drops out.
If the (EXIT) key is pressed, the corresponding
error message appears.
The relay output limit value K2 and the analog output
react as configured under "Error signal" in Chapter
9.4.4 and Chapter 9.6.5.
If "0" is set the function is inactive.
0 to 99999
9.8.2 Current switching opera-
tions Switching operation counter for relay output con-
troller K1
Here, the switching operations for the relay are only
counted if the top limit value for relay switching op-
erations is not set to "0" and is thus inactive.
The value can then be adjusted as required and there-
fore adapted accordingly to the plant.
The switching operation counter remains at 99999.
0 to 99999