Jumbuck 0173343, Инструкция по сборке и эксплуатации

Страница: 8 / 19

1. Ensure the burner control knob is in the “OFF” position.
2. Lift and open the lid of your appliance before lighting.
3. Turn on the LP gas by turning the hand wheel on the
cylinder valve.
4. Turn the burner control knob marked with an igniter
flame to “HI”.
5. If the burner does not light within 5 seconds, turn the
burner control knob to “OFF”. Wait 5 minutes for the
gas to clear, and repeat the above procedure. Use the
Manual directions if it still will not light.
6. When lit, turn the control knob to the desired heat
setting.
LIGHTING THE MAIN BURNER USING
AUTOMATIC IGNITION
TURNING OFF YOUR GRILL
1. Turn off the gas supply at the LP cylinder by turn-
ing the valve clockwise.
2. Turn the burner control knob to the “OFF” position.
WARNING
1. Read instructions before lighting.
2. If ignition does not occur in 5 seconds, turn the
burner control(s) off, wait 5 minutes and repeat the
lighting procedure.
LIGHTING
MANUAL IGNITION
If necessary this BBQ can be lit manually.
1. Open the lid before lighting.
2. Light a
90
mm BBQ match and hold it adjacent
to the left hand side of the burner.
3. Turn the burner control knob to the "HI" position.
The burner will light from the match.
4. When the burner has lit, the burner rate can be adju-
sted by pushing down and turning the knob anti-
clockwise to any position between the “HI” and “LOW”
position.
Always visually inspect your BBQ before lighting.
Replace any hoses that are frayed or cracked before
lighting your BBQ. Look for anything that may be block-
ing spaces for ventilation and remove. After lighting,
always check the flame to ensure you have a good
flame all along the burner. If not able to light, or the
flame is not even along the entire burner, then see the
Troubleshooting section.