Julian Bowen Limited Scorpion Racer Bed, Руководство по сборке, Страница: 5 / 10

Safety Advice
5 OF 10
Please take the time to carefully read through the whole of these instructions before you
commence.
Keep these instructions for future reference.
Unpack, inspect and check off all of the contents.
Please dispose of all packaging safely.
We strongly recommend that you keep children well away from the work area.
It would be sensible to lay a sheet or blanket on the floor where you intend to work to avoid
scratching this product and to protect your floor.
This product is heavy. Take extreme care when lifting to avoid personal injury or damage to
the product.
Assemble the product as close to its intended final position in the room as possible.
We strongly urge that you do not use Power Tools, such as drills or electric screwdrivers
during this assembly as this could cause irreparable damage to you product and will
invalidate the warranty.
IMPORTANT INFORMATION
WARNING : This bed is not suitable for children under 4 years.
WARNING : Do not place this child's bed near heat source, windows and other furniture.
WARNING : Do not use this child's bed if any part is broken, torn or missing.
WARNING : Small component parts could choke a child if swallowed.
It is recommended that you always follow the manufacturer's instructions to assemble this
product.
This product is intended for use by children over 4 years of age.
Children are likely to play, bounce, jump and climb on beds, therefore the child's bed
should not be placed too close to other furniture or windows, blind cords, curtain pulls or
other strings or cords and should be placed either tight to the wall or have a gap of 300mm
between the wall and side of bed.
This bed must not be dismantled.
Replacement parts can be obtained from Julian Bowen Limited where available and at an
addiional cost.
Recommended Mattress Size: 90cm x 190 cm (UK Single) with a depth of no more than 23cm.
It is necessary to frequently ventilate the room in order to keep the humidity low and to
prevent mould in and around the bed.
Please periodically check all the fixings of the item and re-tighten when necessary.
This item conforms to British Safety Standards - BS8509:2008-AI:2011.
HANDY HINT: If you keep the hardware in a bowl during assembly you will be less likely
to lose them.