Working with the timer
27
2. Confirm by pressing
.
The temperature will be adopted as the new target
value and will remain in memory even after the unit is
switched off.
Working with the timer
The
Pearl
has a programmable timer. The decimal
point of the display will blink whenever the timer is
active. As soon as the timer alarm triggers, an audible
signal will be emitted and the display blinks until the
alarm is canceled.
Setting the timers
To set the timer, proceed as follows:
1. Press the timer key
.
The most recently used time is displayed.
2. Use the arrow keys
to set the number of
minutes.
The timer's upper limit is 9001 minutes (150
hours, 1 Min.).
3. Activate the timer by pressing
.
The timer will be activated with the selected time.
The decimal point of the display will blink whenever
the timer is active.
You can also set the timer while the unit is in Standby
mode. Proceed as described above.
As soon as you adopt the time by pressing
, the
timer will start running and the unit will start working.
It starts to heat up to the currently selected target
temperature.
Setting the timer
while in Standby
mode
