Immersion Coolers
13
4.3. Safety
instructions
Follow the safety instructions to avoid personal injury and property damage. Also,
the valid safety instructions for workplaces must be followed.
•
Only connect the unit to a power socket with an earthing contact (PE –
protective earth)!
•
The power supply plug serves as a safe disconnecting device from the line
and must always be easily accessible.
•
Place the unit on an even surface on a base made of nonflammable
material.
•
Do not stay in the area below the unit.
•
Make sure you read and understand all instructions and safety precautions
listed in this manual before installing or operating your unit.
•
Do not touch the immersion probe if it is frosted.
•
Do not bend the tube connection of the immersion probe
•
Keep the air intake and exhaust grids free of obstructions. (Maintain a
sufficient distance from all surrounding surfaces!)
•
Do not move the unit from the position where it was set up during
operation.
•
Always turn off the unit and disconnect the mains cable from the power
source before performing any service or maintenance procedures, or
before moving the unit.
•
Always turn off the unit and disconnect the mains cable from the power
source before cleaning the unit.
•
Transport the unit with care.
•
Sudden jolts or drops may cause damage in the interior of the unit.
•
Observe all warning labels.
•
Never remove warning labels.
•
Never operate units with damaged mains power cables.
•
Repairs are to be carried out only by qualified service personnel.
•
There are thermal dangers: Touchable parts of the probe can be very cold.
Therefore, exercise particular caution when touching these parts. Use
gloves.
WARNING
This product contains chemicals known to the state of California to cause
cancer, birth defects or other reproductive harm.
