Jula UT131, Руководство пользователя

Страница: 16 / 37

UT131 Palm Size Multimeter
-16-
Notes:
*. Before measuring, switch off the power supply of the circuit and carefully check the
input terminal and range position.
*. If the range of the measured current is unknown, select the maximum range and then
accordingly reduce.
*. Please replace the fuse with the same type.
10A jack: F use 10A/250V Φ5×20mm
VΩmA jack
：
Fuse 0.2A/250V Φ5×20mm
*. When measuring, please do not connect the test leads with any circuit in parallel.
Otherwise there is a risk of damage to the device and human body.
*. If the tested current is over 10A, each measurement time should be less than 10
seconds and the next test should be after 15 minutes.
7. AC Measurement (only for UT131A, see Figure 3)
Similar to DC Measurement.
Please refer to Section 6 “DC Measurement (see Figure 3)”