EN
40
5. Unlock the trigger and press until a
continuous jet flows through the nozzle
and brings with it any air from the hose.
6. Release the trigger.
7. Put the switch in the ON position.
FIG. 11
8. Hold the spray gun firmly with both
hands. Point the nozzle at the surface to
be cleaned and press the trigger.
9. Release the trigger to stop the jet, and
switch off. The high-pressure washer is still
charged with high pressure.
WARNING!
Watch out for kickback when pressing the
trigger.
USING DETERGENT
Detergent can only be added when the high-
pressure washer is in low pressure mode.
WARNING!
• Follow the instructions on the safety
information sheet for the actual
detergent, in particular the instructions
concerning personal safety equipment.
• Remove the lid from the detergent
bottle. Carefully pull out the detergent
container from its storage position in the
high-pressure washer.
• Fill the container with detergent. Only
use detergent intended for the high-
pressure washer.
• Press the detergent bottle with the
opening down in the connection for
detergent in the hose.
RECOMMENDED METHOD
• Spray the detergent thinly on the dry
surface and allow to act, but not to dry.
• Hose off the detergent and dirt in
high-pressure mode.
3. Vent the high-pressure washer as follows
before use:
1. Start the product with the power switch.
2. Unlock the spray gun catch.
3. Press the trigger. The product starts
working.
4. Allow the high-pressure washer to run
until water without bubbles comes out
through the nozzle.
NOTE:
Do not run the high-pressure washer
without liquid for more than 2 minutes,
this will damage the high-pressure pump.
If the pressure is not sufficiently high within
2 minutes, switch off the high-pressure
washer and follow the instructions in the
troubleshooting guide.
5. Lock the spray gun with the catch.
HIGH-PRESSURE WASHING
IMPORTANT:
• Hold the nozzle at least 30 cm from
painted surfaces when cleaning to avoid
damage.
• Check that the power switch is in the off
position and plug the plug into a
correctly installed power point.
NOTE:
The high-pressure washer should be placed
upright on a level, stable surface when in use.
FIG. 10
1. Connect the water supply and plug in the
plug.
2. Open the water tap.
3. Hold the spray gun firmly with both
hands.
4. Point the nozzle at the surface to be
cleaned.
Содержание MEEC TOOLS 009875
