Jula Hard Head, Руководство по эксплуатации

Страница: 25 / 26

EN
25
7. Check measure the position of the other bracket.
8. Repeat steps 4-6 to mount the other bracket. NOTE: A third bracket is only needed for blinds
that are 120 cm or wider.
HANG UP THE BLIND
1. Check that the blind cords hang inwards towards the room and that the bracket tabs are
pointing out.
2. Place the top rail on the brackets (diagram 4).
– If a third bracket is mounted, check that it fastens correctly to the rail.
3. Fold in the tabs and press them to lock (diagram 5).
4. Fit the two parts of the rod together. Hook the rod on the hook in the top rail.
FIT THE CORD HOLDER
1. Fit the cord holder on the window frame or wall.
2. Screw on the safety device with suitable screws (diagram 7).
3. Wind the blind cord round the cord holder so that it is out of the reach of children.
FIT THE BLIND SUPPORT
Use the blind support as a support to hold the blind in place, for example when airing.
1. Fit the blind according to the instructions and check that the top rail is firmly in place.
2. Lower the blind and place the blind support with the pins in each end of it under the rail.
3. Place the blind support against a suitable mounting surface.
4. Remove the blind and mark out the attachment points with a pencil.
5. Screw on the blind support with suitable screws (diagram 8).
6. Use the blind support by fastening the blind support pins in the holes in the bottom rail.
ADJUST THE CORD STOPS
1. Fit the blind according to the instructions and check that the top rail is firmly in place. Lower
down the blind to the required position and lock in place.
2. Measure the distance from the top rail to the cord stops.
– If the cord stops come 25–50 mm below the top rail no further adjustment is necessary.
The blind is now ready to use (diagram 9).
3. Undo the cord stop knot to adjust the cord so that the cord stop is 25–50 mm below the top rail
(diagram 10).
4. Pull out the cord stop knot to fix the cord stop in the right place.