EN
10
DESCRIPTION
A Triangular support
B Anchor rod
D Base
E Lower lamp post
F Plastic expander
G Sleeve
H Upper lamp post
I Adapter
J Bulb
K Post head
L1 Terminal block
L2 Terminal block IP44
M1 Nut M10 and washer
M3 Bolt M6 x 16
M4 Bolt M5 x 10
M5 Bolt M5 x 5
M7 Nut
M8 Screw
FIG. 1
INSTALLATION
Base
1. Dig a hole with an even bottom, size 25 x
25 x 14 cm.
2. Pull the power cords through the bottom
of the hole and 25 cm above ground level.
3. Fit the three anchor rods (B) on the
triangular support (A).
4. Pour 4 cm of ready-mixed cement into the
hole. Place the anchor rods and support
vertically in the cement. Fill with cement
to ground level.
5. Make sure the anchor rods fit the lamp
post base. If not, rotate the rods to the
correct position.
SAFETY INSTRUCTIONS
• Only intended for outdoor use.
• The lamp must only be installed by an
authorised electrician.
• The lamp must only be used in complete
condition, with the lamp glass in place.
• Disconnect the lamp from the mains
supply before repairing or maintenance.
• The lamp must be installed by an
authorised electrician.
• To avoid accidents in public places take
local regulations and safety instructions/
warnings into consideration.
• Only use an approved cable to connect
the outdoor lamp to the mains. The
external cable must as a minimum
comply with the requirements for cable
type H05RN-F in terms of its mechanical
and electrical properties and the wires
must have a cross-sectional area of at
least 1.0 mm².
WARNING!
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge, you
may replace switches and power points, fit
plugs, extension cords and light sockets.
If not, you should contact an electrician.
Incorrect installation can result in electric
shock or fire.
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz
Output
Maximum 3 x 100 W
Socket E27
Protection rating
IP44
Height
227 cm
Содержание Anslut
Страница 3: ...1 2...