ENGLISH
9
check the accuracy. The screws (I) may need to be further adjusted so that both the 180° (C) spirit
bubble and the bottom bubble (G) are correctly shown.
5.
The mounting plate has a 360° scale and can be turned 360°. Release the lock screw opposite the
levelling screw (F) to turn the mounting plate (E). Turn the plate to the position required and tighten
the screw.
6.
Switch on the tool by turning the power switch (B) until it clicks. Switch off by turning the switch
again.
To make minor adjustments to the height of the stand, release the lock handle (K) and turn the
handle to adjust the stand (J) to raise or lower the stand to the height required in relation to the
work area.
Examples of use
Direct horizontal measurement
Mounting of object at the same height
Renovation work: erection of partition walls, levelling of floors etc.
Levelling outdoors using marker poles
MAINTENANCE
Replace the batteries when the laser beam gets weaker. Replace the batteries with new ones of
the same type. Remove the batteries if the tool is not going to be used for some time.
Do not expose the tool or accessories to rain or damp conditions.
Before use, check the tool for worn or damaged parts.
Do not use the tool if it is not working properly.
Repairs must only be carried out by qualified personnel.
Only use the supplied accessories, or accessories recommended by the manufacturer.
Jula reserves the right to make changes. In the event of problems, please contact our service
department.
www.jula.com