Jula 059079, Руководство по эксплуатации, Страница: 30 / 37

ENGLISH
30

Repairs must only be carried out by qualified personnel.

This power tool has been manufactured in compliance with current safety standards and
requirements. Repairs may only be carried out by qualified personnel using identical spare parts.
Improper repairs may pose a risk of injury/death or damage to property.
Special safety instructions

Do not spray flammable substances.

The tool must not be cleaned with solvent that has a flash point lower than 21°C.

Read and follow all the information on the container for the sprayed material, including information
concerning personal safety equipment.

Never spray any material if you are not familiar with its properties.

The tool must not be used for spraying material with a flash point lower than 21°C.

Do not use the tool in explosive environments, such as in the vicinity of flammable liquids, gases or
dust.

Do not use the tool near any sources of heat, including lighted cigarettes, naked flames, hot
objects, electrical sparks, etc.

Unplug the power cord before doing any work on the tool.

IMPORTANT: Wear safety glasses and a face mask.
WARNING:

Never point the spray jet at yourself, at others or at animals.

Make sure there is adequate ventilation to avoid solvent fumes being sucked into the tool.

Pay attention to the direction of the wind when working outdoors. The wind can carry the spray and
cause damage.

Do not allow children to use the tool.

Never open the tool casing and attempt to repair any electrical faults.

Never place the tool on its side.
Other risks

Even if the tool is used in accordance with the instructions it is impossible to rule out all risk factors.

The following are potential risks associated with the type and design of the tool.
-
Damage to lungs (if effective face mask is not worn).
- Damage to ears (if effective ear protection is not worn).
- Vibration injuries (if the tool is used for long periods, or is not handled and maintained
correctly).
WARNING: The tool produces an electromagnetic field during operation. This field can in some
circumstances affect active or passive medical implants. If you have a medical implant you should consult
your doctor and/or the manufacturer of the medical implant before using the tool to reduce the risk of
serious personal injury or death.
TECHNICAL DATA
Rated voltage 230 V ~ 50 Hz
Output 600 W
Safety class II
Container volume 700 ml
Sound pressure level LpA 78 dB(A), K=3 dB(A)
Sound power level, LwA 91 dB(A), K=3 dB(A)
Vibration 0.1 m/s
2
, K=1.5 m/s
2
Always use hearing protection!
The declared vibration and noise value, which has been measured by a standardised test method, can be
used to compare different tools with each other and for a preliminary assessment of exposure. The
measurement values have been determined in accordance with EN 50580:2012
.
WARNING:
The actual vibration and noise level when using power tools may differ from the specified
maximum value, depending on how the tool is used and what kind of workpiece is processed. It is
therefore necessary to determine which safety precautions are required to protect the user, based on an
estimate of exposure in actual operating conditions (taking into account all stages of the work cycle, e.g.
the time when the tool is switched off and when it is idling, in addition to the start-up time)
.