juju Eat&Joy, Руководство пользователя, Страница: 5 / 20

5
EN
Installation & use
Frame
1. Unpack the frame
2. Press the two red buttons on the back and slide the frame to open it.
(see figure 1+2)
3. There are two rods available (1x thick and 1x thin). Please connect the
two sides with the thicker rod (picture 2) and fix the bar with the
supplied screw in the specified holes.
4. Insert the end of the rod in the plastic rails and fasten the rails with:
(Warning! This high chair comes in two versions)
a. The 4 small screws
b. Or insert into the plastic rails and push it up until the small
buttons on the frame click into the plastic rails. (see figure 3)
Seat
1. Press the seat into the holder which is located above. (Please note that
the slots are in the correct place.)
2. Fasten the seat using the thin rod. then secure the brackets at both ends
of the rod. (see figure 4)
To attach the footrest, first insert the left side of the footrest and then
the right side. (see figure 5)
Rollers
1. It‘s easiest if you put the chair on its side.
2. Slide the rollers into the rear plastic rails (see figure 6)
3. Supplied with 2 * rear rollers and 2 * front stopper
4. The rollers are equipped with brakes