Advanced Matrix Display (LCD Display) Instruction Manual
Note: Because there is a small error rate in the Amp and Voltage measurements. The
Watt-hour value will also have some degree of error. The measurement should be used
for informational purposes and not used for scientific measurements.
Assist Level
The assist level indicator shows the assist level you are in at any given moment. It is
visible in both the advanced and the standard display modes.
Speed
The speed indicator measures the speed of the bike. This value is measured from the
motor’s internal speed sensor. If you have changed to a new tire with a larger or smaller
diameter than the included tire, You may need to manually adjust the wheel speed
setting.
Controller Temp
The controller temperature is measured by a temperature sensor mounted inside of the
controller near the transistors. The temperature is displayed displayed on the screen in
Celsius. When the e-bike is under load, the controller’s temperature will increase. The
bike’s performance will began to decrease when the temperature exceeds 80 degrees
Celsius.
Trip Distance
The trip distance counts up from zero. The distance is calculated by each rotation of
the rear wheel. The trip distance can be reset from the instructions provided above.
Adjusting Parameters in the Setup Menu
There are a few parameters that you are allowed to adjust to control the behavior of
your e-bike.
To enter the settings menu:
Hold the assist Up and Assist down buttons for about 3 seconds then release. You
will now enter the Setup Menu. Here you can adjust a few settings to control the
behavior of the e-bike.
Advanced Matrix Display (LCD Display) R2017-12-01
8
