Juguetronica Space Basket Zero Gravity, Инструкция по эксплуатации

Страница: 9 / 20

9
We tried to make a transmitter that would work for right-handed and left-handed people, but it
was impossible and finally we were only able to make it for right-handed people. Therefore, if you
decide to use it on your left hand, you will find that the flight is much less intuitive and the controls are
somehow "inverted." As of this point on, all the explanations are taking into account that the controller
is being used in the right hand.
First, place the transmitter between your thumb
and the forefinger, placing the charger part in the
direction of the tip of your fingers (as shown in
the picture).
Now move the controller a little until you feel it in a comfortable position and reach the joystick
well. Make sure you can move the joystick in all four directions. Reposition the ribbon to the new
position and tighten it to set the optimum position of the controller in your hand.
Then insert the tape through its hole and tighten it
slightly.
HOW TO ADJUST THE TRANSMITTER AND THE BELT
1. Connect the battery cable to the drone power input. Insert the battery into the bottom compartment
of the Spaceball and be extra careful with the housing.
2. Activate the on/off switch on the Spaceball and the lights will start to blink, first quickly and then
more slowly, switching between red and blue.
3. Place the transmitter in your right hand and tighten the strap. Use the on/off button. The red light
on the transmitter will turn on and start flashing.
4. When the transmitter and Spaceball light stop blinking, it means they are correctly synchronised.
Your Spaceball is ready to take off.
TIP: Make sure your Spaceball is on a flat horizontal surface during the synchronisation
procedure, so the flight is stable.
SPACEBALL AND TRANSMITTER SYNCHRONISATION