Judo PROFI-PLUS, Инструкция по установке и эксплуатации

Страница: 10 / 28

10 JUDO PROFI-PLUS / JUDO PROFI-QC
Installation
4.1.2 Installed position
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Always install the filter in a vertical position
(± 5°)!
Failure to observe this can cause uncon-
trolled backwashing water to escape and
can result in damage caused by water.
4.1.3 Mounting the built-in rotary
flanges
Install using the supplied built-in rotary
flange. The built-in rotary flange is used as a
connecting element between the pipe and
the filter.
It is suitable for both horizontal and vertical
pipes.
The built-in rotary flange must be in-
stalled in the direction of flow. This is
marked by a cast in arrow (see fig. 4).
Failure to comply with this means the filter
cannot work.
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
The flange surface of the built-in rotary
flange must be in a vertical position! The
built-in rotary flange must be fitted so that
mechanical stresses cannot occur! Other-
wise mechanical damage can result, the
pipe may burst or the built-in rotary flange
can break. This can result in major water
damage.
In this case, people close to the filter are ex-
posed to a health risk due to the large quan-
tities of water.
Therefore, during installation, ensure that no
large forces act on the pipe, built-in rotary
flange and filter.
4.1.4 Installing the Backwash
protective filter
The built-in rotary flange for the filter is
supplied with bayonet drill holes. The neces-
sary seals and screws for this filter have
already been mounted.
Do not unscrew the screws!
– Insert the four flange screws in the
bayonet drill holes on the built-in rotary
flange (see fig. 3 I).
– Turn the filter in a clockwise direction as
far as it will go (see fig. 3 II).
– Tighten the four flange screws.
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
The section of the profiled flange gasket
must point towards the built-in rotary flange.
Failure to observe this can lead to leaks and
water escaping. This can in turn cause water
damage to the house and its installations
(see fig. 4).
Fig. 3: Built-in rotary flange with bayonet fixture
Select the torque (approx. 4 Nm)
so that the gasket closes and the
filter is not damaged or strained!
I II