Judo i-soft, Инструкция по установке и эксплуатации

Страница: 23 / 32

JUDO i-soft 23
Faults
6. Faults
In order to ensure unit safety and leak tightness, only approved persons may open the
units and replace parts subject to water pressure.
Deleting the fault:
Display text Cause Remedy
Fault no. 1 Drive is defective. Contact customer service. Unplug the power
supply device. If available, switch the bypass
valve to bypass operation.
Fault no. 2 Salt/brine container
too full or leaking Check brine level in salt/brine container.
Unplug the power supply device for 5 seconds
and reconnect again. If failure persists, con-
tact customer service.
Fault no. 3 Time out during
refill Water supply might be interrupted. If the
cause cannot be found, contact customer
service.
Disconnect the transformer from
the socket. Plug it back in after
approx. 5 seconds!
Please always indicate the device
and order number (see chapter
“Technical specifications”).