Judo i-soft, Инструкция по установке и эксплуатации

Страница: 13 / 32

JUDO i-soft 13
Installation
4.5 Connecting the softener with the salt container
1 Filling hose (blue)
2 Suction hose (black)
3 Electrode cable connector
(Avoid any and all contact with water before
connection!)
4 Overflow hose
5 Wall spacer
The salt container is assembled as
follows (see fig. 9):
1. Push the filling hose (1) (blue) through
the opening in the salt container and
slide it over the connecting piece.
2. Push the suction hose (2) (black)
through the union nut and gasket as far
as it will go and manually tighten it.
3. Push the connector (3a) of the electrode
cable into the cable housing (3b) as far
as it will go.
Place the salt container below the water
softener or next to it on the floor.
4. Slide the overflow hose (4) over the
connecting piece.
5. Screw the wall spacer (5) on approx.
30 mm (1.2 inch).
Fig. 9: Salt container assembly
2
3a
4
1
3b
5
When doing so, pay attention that
the white marks on the connector
(3a) and the cable housing (3b)
correspond (correct polarity)!
During assembly the connector
and the cable housing may not
come into contact with water!