6
JUDO EASY DOS
Product Information
2.2
Notes on special dangers
2.2.1 Electrical equipment /
installations
Electrical devices / equipment that are not
splash-water proof and are situated in the
direct vicinity of the phosphate dosing unit
may be damaged by water leaking from the
phosphate dosing unit caused as a result of
the device not being operated in accordance
with the manufacturer’s specifications. In
addition this may also result in short circuits
where these electrical devices / equipment
being connected to the electrical power
supply. In the event of such cases persons
are at risk and may sustain electrical
shocks. Therefore any electrical devices /
equipment situated in the direct vicinity
should be splash water proof, respectively
comply with the statutory requirements for
wet areas (IP44).
3.
Product Information
3.1
Intended purpose
This phosphate dosing unit is suitable for
use in cold drinking water up to a water tem-
perature of maximum 30 °C (86 °F).
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Please refer to the chapter on “Intended
Use” for use restrictions.
3.2
Materials used
The materials used are physically, chemi-
cally and corrosively resistant against the
loads that can be expected in the drinking
water und fulfil the DIN EN 13443-1 and DIN
19628 standards ("Mechanically operated
phosphate dosing unit in the water installa-
tion"). All materials are physiologically and
hygienically safe. Metallic materials fulfil the
requirements of the German DIN 50930-6
standard ("Impact on the Drinking Water
Quality"). No electrical cables and devices
may be located underneath or in the imme-
diate vicinity of the phosphate dosing unit!
There must not be any electrical
cables and devices underneath or
in the immediate vicinity of the
phosphate dosing unit!
