Installation
3.2
Installation of the rotary
flange fitting
CAUTION
The flange surface of the rotary
flange fitting must be upright!
The rotary flange fitting must
be fitted so that it is free from
mechanical stress or strain. Oth-
erwise mechanical damage to the
pipe or the rotary flange fitting up
to and including breaks can result.
The built-in rotary flange serves as a con-
necting element between the domestic
water installation and the device. It is suit-
able both for horizontal and vertical pipes.
Attention:
Install the built-in rotary flange
in the flow direction! This is indicated by an
arrow integral with the casting.
INFO_NO_HEADER
If the installation is twisted, a func-
tioning of the device is not possible.
1
2
Fig. 2:
Rotary flange fitting
1
Profile flange seal
2
Flow direction arrow
3.3
Installation of the device
CAUTION
If no bypass valve is installed, a
shut-off valve must be installed
upstream and downstream of the
unit in order to interrupt the water
supply during installation, mainte-
nance, repair or malfunction of the
device.
Install the device in a vertical
position (± 5°); the connection
for waste water from backwash-
ing must be directed downwards.
Otherwise, water may escape and
cause water damage.
For the installation of the device
in domestic water piping, only use
the supplied built-in rotary flange
(see chapter 3.2).
The flange surface of the rotary
flange fitting must be upright!
For proper sealing the profile of
the profile flange seal must point
towards the rotary flange fitting
(see Figure 2: Rotary flange fitting,
Fig. 3:
Attach and engage appliance
1
Insert screws
2
Turn clockwise to engage screws
Fig. 4:
Connection of appliance
engaged
Do not undo the screws of the device!
1.
Insert the heads of the four flange
screws through the bayonet holes on
the rotary flange fitting (see Figure 3).
1702272 • 2020/07
JUDO JPM+
9
