Electric Potato Peeler
Assembly
1. Check that the On/Off Switch is
set to off before assembly.
2. Place the Bowl onto the Base
Unit ensuring the Lower Cut-
Out Switch is aligned. Failure to
position correctly will prevent the
Potato Peeler from operating.
3. Place the the Peeling Disk* onto
the axis inside the Bowl .
4. Add enough potatoes to the Bowl
to cover the Peeling Disk*
(maximum of 1kg).
5. Add a little water (maximum 200ml)
to the Bowl aid peeling.
6. Place the Lid onto the Bowl
with the ’T’ section to the rear. The
’T’ section must slot into the Upper
Cut-Out Switch at the rear of the
bowl.
7. Push both the front and rear Lid
Clips upwards to lock the Lid (4)
into place.
Tips
■
Do not use baking potatoes, as
these are too large, for best results
cut your potatoes so that they
measure no more than 5cm x 5cm.
■
Wash potatoes in fresh water before
cooking.
■
Sprinkle with flour, before putting in
the oven.
Peeling Potatoes
1. Plug the Potato Peeler into the
Mains socket
2. Set the On/Off Switch to
—
(On).
3. The Potato Peeler will begin to
function. (The appliance may
vibrate during use but the rubber
feet keep the appliance from moving
significantly).
4. As a rough guide, the Potato Peeler
should take around 2 minutes
to peel a quantity medium sized
potatoes. Due to potatoes varying in
size and shape, this time may vary.
Smaller potatoes will give better
results than large.
5. Check progress regularly, never allow
the machine to operate continuously
for longer that four minutes and
allow ten minutes between each
four minute use period.
6. Once potatoes are peeled set the
On/Off Switch to
O
(Off).
7. Unplug the Potato Peeler from
the Mains socket.
8. Remove the potatoes from the Bowl
.
9. The Potato Peeler can not remove
skin from recesses or irregular
shapes. Remove any remaining skin/
eyes by hand using a small knife.
■
Wash potatoes in fresh water before
cooking.
