Page 3
Before first use
Before first use or after a long period
of storage the coffee maker should be
flushed through.
• Site the coffee maker on a level stable
surface - the rubber feet should all
fully contact the surface to ensure
stability.
• Slide the Water Tank
2
upwards and
remove. Fill to the MAX level shown
on the casing with cold water. Replace
the water tank, ensuring that the
valve at the base is properly seated.
• Insert the Filter Holder
6
into the
Bayonet Housing
5
(see A below);
the filter holder handle needs to be
just to the left of the graduations on
the bayonet collar to allow insertion.
Secure the filter holder in the bayonet
housing by rotating it right (see B
below), until it tightens.
• Turn the Steam Control Knob
21
clockwise to the minimum setting.
• Ensure all switches
14
,
17
and
19
are
OFF (in their upper position).
• Plug the Power Cable
10
into
your socket (check your supply
is compatible with the Rating
Information).
• Press the POWER Switch
14
down to
switch ON. The POWER Indicator
15
will illuminate and the water in the
boiler will start to heat.
• Place a heat resistant jug under the
Steam Nozzle
4
.
• After a few minutes, the water will
reach temperature for use and the
Espresso Ready
Indicator
16
will
illuminate.
• Turn the Steam Control Knob
21
anti-
clockwise to maximum.
• Press the PUMP Switch
19
down to
switch ON - the PUMP ON indicator
20
will illuminate and water will flow
from the Steam Nozzle
4
.
• Allow about half a jug full of water
to flow, then press the PUMP Switch
19
down again to switch OFF (upper
position, indicator goes out), and turn
the Steam Control Knob
21
clockwise
to minimum. Discard the collected
water.
• Place the heat resistant jug under the
Filter Holder
6
.
• Wait for the Espresso Ready
Indicator
16
to illuminate.
• Press the PUMP Switch
19
down to
switch ON - the PUMP ON indicator
20
will illuminate and water will flow
from the Filter Holder
6
.
• Allow about half a jug full of water
to flow, then press the PUMP Switch
19
down again to switch OFF (upper
position, indicator goes out). Discard
the collected water.
• Press the POWER Switch
14
down
again to switch OFF (upper position,
indicator goes out).
How to use
Making Espresso coffee
Using ground coffee
• Slide the Water Tank
2
upwards and
remove. Fill to the MAX level shown
on the casing with cold water. Replace
the water tank, ensuring that the
valve at the base is properly seated.
• Turn the Steam Control Knob
21
clockwise to the minimum setting.
• Ensure switches
17
and
19
are OFF (in
their upper position).
• Press the POWER Switch
14
down to
switch ON. The POWER Indicator
15
