Page 14/27
The Quality Connection
6-3.
Lower Die Part
6-3-1
Do not move die block (No.112) and side block (No.114) that have been preset on the
die plate (N0. 114) by JST. These blocks properly set the position of the crimper
anvils in the side-to-side and front to back directions. Install spacer (No.164), crimper
anvil (A) (No.163), crimper anvil (B) (No.162), shear blade supporter (No.160), shear
blade base (No.161), shear blade spring (No.159), shear blade (No.158) in order and
tighten with two bolts from the back of die block (No.112).
6-3-2
When tightening the two bolts, do so slowly alternating between the two bolts until
they are snug. Be sure all parts are pushed against the side block (No. 114) and
finish tightening.
