JSGCT60
Installation and Operating Instructions
3
Service Mode
The service mode consists of nine settings split in to three functional areas:-
1. Programming credit
2. Option settings
3. Audit functions
To access service mode remove the coin box, press and release button B (Figure 4) to
step to the desired setting number (St.01 to St.10). Simultaneously pressing and
releasing both buttons A and B will step back to the previous setting. On reaching the
required setting number press button A to enter desired values.
Figure 4 - Front Panel
Programming credit
The
JSGCT60
may be programmed for either single coin mode or totalise mode.
Totalise
mode must be configured by the distributor to be enabled. In totalise mode
the meter
will display the amount of money required and intermittently show ‘FEE’.
This value
will be reduced as money is entered. Once the correct amount of money has
been
entered the session will begin.
To programme credit press and release button B to step to the desired setting number.
When the required number is showing on the display press and release button A to
display the existing setting. Press and release button A to select the digit to be changed
then press and release button B to alter that digit.
Flashes when credit
exceeds 100 hours
Flashes when
display is showing
MM:SS
Flashes when credit
remaining is
counting down
Hidden programming
button A
Hidden programming
Button B
