45 | Operation
2.3.5 Sensors
Sensor information includes all sensors except positioning sensors. Information and settings are displayed on the
Sensors Screen (Figure 36: Sensor Screen on page 45), accessible by pressing the Sensors tab at the top of the
large Screen.
Figure 36: Sensor Screen
2.3.5.1 Available Sensors
For an overview of the available sensors check the overview in Figure 3: Sensor Overview on page 14.
2.3.5.2 Motion Sensor
The DP Operator Workstation SENSORS screen provides the following info / functions:
•
MRU section (suitable for 3 different MRU devices):
•
Comport Status / sample time.
•
Check box to use this reference device.
•
Display of raw values Roll / Pitch / Yaw and Heave (if available).
•
Parameter for manual rating per device (0~10).
•
Sensor weighing section.
•
Display of calculated rating.
•
Display of deviation from weighed over a longer period.
•
Display of error from weighed.
•
Weight bar graph (0~1).
•
Parameter for filter time (moving average filter, default set at 0.2sec.).
•
Parameters for adjusting factors for the weighing rating / deviation/error (0~10).
•
Display of weighed List / Trim used by the DP controller.
Содержание Alphatron Marine AlphaDynaPos
Страница 1: ...AlphaDynaPos Ship Automation and Navigation system Operation Manual www jrc am ...
Страница 5: ...5 Contents 4 2 Appendix B Checklist for Taking DP system into Operation 85 ...
Страница 13: ...13 Introduction III 3 System Overview DP2 Figure 2 system Overview DP2 ...
Страница 14: ...14 Introduction III 4 Sensor Overview Figure 3 Sensor Overview ...
