JR Vibe 90SG, Руководство по сборке

Страница: 8 / 106

8
Bearing Case Direction
Top
Bevel Gear Assembly
Cross Member,
28mm (4pcs)
Bearing, 5 x 13 x 4mm
Tail Pinion Unit B
Socket Head Bolt,
2.6 x 8mm (2pcs)
Tail Pinion Shaft
Tail Pinion Unit Bearing Case A
(Bearing 5 x 13 x 4mm)
Tail Pinion Unit A
Complete Assembly
Install the bearing
case as noted in
the drawing.
1-3 TAIL DRIVE TRANSMISSION ASSEMBLY
1-4
Cross Member, 28mm (4pcs)
Setscrew, 4 x 4mm (2pcs)
Washer, 5 x 7 x 0.5mm
Nylon Lock Nut,
2.6mm (2pcs)
Setscrew, 4 x 4mm (2pcs)
Socket Head Bolt, 2.6 x 8mm (2pcs)
Nylon Lock Nut, 2.6mm (2pcs)
Washer, 5 x 7 x 0.5mm (1pc)
Front
Flat Head Screw, 2 x 8mm (8pcs)
Steel Joint Ball (8pcs)
T-Arm L
Elevator Control Arm
Flat Head Screw,
2 x 8mm (8pcs)
T-Arm Lever (2pcs)
Steel Joint Ball (8pcs)
T-ARM LEVER ASSEMBLY
T-Arm R
Elevator Arm
Setscrew, 3 x 6mm (1pc)
Bevel Gear Pin (1pc)
Bevel Gear Pin
Bevel Gear T25
Setscrew, 3 x 6mm
d
e
R
de
R
)2
x(
d
e
R
(x3)
d
e
R
(x3)
d
e
R
(x2)
Tail Pinion Gear T22
Poly Slider, 0.13mm (1pc)
Poly Slider, 0.13mm
(for gear mesh adjustment)
Complete the full assembly but fasten the Tail Pinion
Gear T22 two 4x4mm setscrews last while pushing down
on the T22 gear and pulling up on the shaft and T25
bevel gear. This ensures correct bevel mesh, and no up/
down slop in the shaft assembly. Secure so that the set
screws are engaged on the shaft flats.