NXU-2A Operations Manual
3-2
Interoperability Now!
The NXU-2A includes a Windows program (the
NXU-2A Setup Utility
). It
provides a graphical user interface for configuring the unit via the serial port.
This program allows NXU-2A settings to be chosen from a menu and then
sends the appropriate commands to the device. Alternatively the NXU-2A may
be configured manually using any RS-232 terminal program. Both methods are
described. If you want to use the
NXU-2A Setup Utility
you may skip to Section
3.3.1
Configuration Using an RS-232 Terminal Program
A terminal program is needed to communicate with the NXU-2A for initial configuration. A
suitable Windows terminal program, MTTTY.EXE, is included with the unit. This program
may be run directly from the floppy diskette or it may be copied to your hard drive and
executed from there. This program is also available from JPS Customer Service.
After running MTTTY and setting the parameters listed above your screen should look like
this:
Figure 3-1 MTTTY Terminal Screen
Choose the COM port appropriate for your computer and then click the Connect box.
Note: When using MTTTY you must click the Connect box to enable serial
communications.
Содержание NXU-2A
Страница 12: ...NXU 2A Operations Manual 1 6 Interoperability Now This Page Left Intentionally Blank...
Страница 16: ...NXU 2A Operations Manual 2 4 Interoperability Now Figure 2 1 Outline Dimensions...
Страница 17: ...NXU 2A Operations Manual Interoperability Now 2 5 Figure 2 2 Control and Connector Locations...
Страница 54: ...NXU 2A Operations Manual 7 2 Interoperability Now This Page Left Intentionally Blank...