JPRiDE JPT2, Руководство пользователя, Страница: 14 / 15




8. Notes and FAQ
A．apt-X LL
apt-X LL is workable only in TX mode, and the bluetooth device which connected with
JPT2
also support apt-X LL; if the device only support apt-X
，
it will automatically switch
to apt-X code
，
otherwise both are SBC; when 1 with two automatically switch to SBC
B．Automatic power off
In RX mode, disconnect any device more than 10 minute or the battery voltage under
3.05V it will automatic power off; in TX mode battery voltage under 3.05V automatic
power off
C． How to re-connect？ What can we do when it can’t re-connect？
After
JPT2
connect with bluetooth device successfully, hereafter it will re-connect with
your device per power on, if can’t re-connect, please pair again
D. How to clear up the paring list？
Once switch the status, the pairing information for the former mode will be cleared up. So
you only need to switch the status then power on, the paring list will be cleared up.
E. What is the paring password ?
If some devices connect with
JPT2
need enter password, you can try to enter 0000 (four
0
）
F. If there are some problems such as can ’ t power on, connect failed, what
can we do？
You can try to reset it, press the MFB meanwhile insert charging cable to charge, then
reset is OK, power on again can normal use.
G. What are the charging voltage and current？ What devices can charge
for it？
As long as the car charger, travel charger, computer USB and so on which their DC
voltage is 5V, current exceed 500mA can charge for
JPT2
.