JP-Australia AllroundAir SE, Руководство пользователя, Страница: 3 / 5

9” fin
10”
fin
Kick-up fin
5 4
3
- Connect
the pump hose
to the valve and
pump
1
- Carefully roll out
the board
2
- Push down and
turn the valve pin
Pin up to inflate
4
- Turn from
double action to
single action
when it is
difficult to pump
5
- Pump
your board to
15 psi (1 bar)
Any use of an air compressor may
result in poor performance or damage
to the board, and automatically avoids
all warranties. If you leave your board
exposed to the hot sun, check the
pressure and deflate it slightly. Otherwise
the board may become over inflated
and stretch the material. The ambient
temperature affects the tube’s internal
pressure: a variation of 1°C/ 1.8°F
causes a variation of the pressure in the
tube of +/- 4 mBar (0.06psi).
Warning
Instructions to inf late your board: Inserting the fins:
1
- Insert the
front part of
the fin into the
finbox
2
- Push the fin
into the finbox
3
- Tighten
the screw
2
-
Insert the fin
and align the holes
4
- Push the
bungee into the
recess
3
- Insert
the pin
1
- Insert the
plate into the
finbox
1
-
Place the
fin base on the
correct position
2
- Push the plate
towards the front
edge of the finbox
3
- Insert the pin of the fin
into the finbox cavity and push
the fin into the finbox
4
- Push the fin into the finbox
and tighten the screw
5