23
26
25
24
Calibration
The thermometer is initially calibrated at the time of manufacture.
If the thermometer is used according to the use instruction, periodic
readjustment is not required. However, We recommends checking
calibration every two years or whenever clinical accuracy of the
thermometer is in question. Please send the complete device to the
dealers or manufacturer.
The above recommendations do not supersede the legal requirements.
The user must always comply with legal requirements for the control
of the measurement, functionality, and accuracy of the device which
are required by the scope of relevant laws, directives or ordinances
where the device is used.
A clinical summary and procedures for checking calibration are
available upon request.(Turn on the thermometer and press the Power
button long time until entering into calibrate mode, software
version
will be displayed.)
Symbol Explanation
Troubleshooting
Problem
Solution
Error message
The thermometer is not
functioning properly.
Unload the battery,
wait for 1 minute and
repower it. If the
message reappears,
contact the retailer
for service.
The ambient temperature
is not within the range
between 5
℃
and 40
℃
(41
℉
~
104
℉
).
Place the
in a room for at least 30
minutes at room
temperature between
5
℃
and 40
℃
(41
℉
~
104
℉
)
thermometer
Troubleshooting
Caution
95%
15%
131
o
F
-13
o
F
Manufacturer
Manufacturing
Date
Direct Current
Batch Code
Storage and Transportation Temperature
Limit: -13
℉
~131
℉
(-25
℃
~55
℃)
TYPE BF APPLIED PART
Refer
to
instruction
manual
/
booklet
General
symbol
for
recovery
/
recyclable
Disposal
of
this
product
and
used
batteries
should
be
carried
out
in
accordance
with
the
national
regulations
for
the
disposal
of
electronic
products
.
106kPa
70kPa
Atmospheric pressure limitation
Storage and Transportation
15%~95%RH
Humidity limitation:
The first num.2:Protected against solid foreign objects of 12,5
mm and greater.
The second num.2:Protection against vertically falling water
drops when ENCLOSUREtilted up to 15
°
.
IP22
In Forehead mode:
Temperature taken is
higher than 43.0
℃
(109.4
℉
).
In Object mode:
Temperature taken is
higher than 100
℃
(212
℉
).
Problem
Solution
Error message
In Forehead mode:
Temperature taken is
lower than 34.0
℃
(93.2
℉
).
In Object mode:
Temperature taken is
lower than 0
℃
(32
℉
).
Read Temperature Taking
Hints Thoroughly, then
take a new temperature
measurement.
Read Temperature
Taking Hints thoroughly ,
then make sure the lens
filter are clean, then take
a new temperature
measurement.
The thermometer could
not
work due to low
battery.
Replace two new
alkaline batteries
size AAA.
When battery outline
flashes, it indicates that
the power is low, but you
can continue to measure.
The thermometer works
properly.
Use the thermometer
normally
The thermometer will take
a proper measurement but
batteries must be replaced
soon.