Joyner Renegade R2, Руководство пользователя

Страница: 42 / 278

42
/
278
4
Tighten the differential oil outlet bolt.
5 Remove the oil inlet bolt; fill oil (API 80(75) W-90 GL-3 Gear Oil) about 0.4 liters.
6 Replace the oil inlet bolt, and tighten with 30Nxm torque.
The inlet bolt has magnetism to adsorb scrap iron in the oil, so never use a bolt without magnetism to
replace it.
Engine coolant
The radiator is located in the front of your Renegade to absorb cool air easily to cool the engine well.
You must check the coolant for level and leaks. If it is low, you need to refill coolant into the radiator
(approximately 6000 ml). The lack of coolant will cause the engine to overheat and engine damage.
Maybe because the water hose is very long and there is some difficult to fill coolant. Please do the
follow step by step.
1 Put the vehicle on level ground, shut down the engine and let the coolant cool fully.
2 Remove the front/rear inlet cap and the cap of reserve cool tank.
3 Fill the coolant into the front inlet slowly until coolant comes out from the inlet, then cover the
cap.
4 Fill the coolant to reserve coolant and then cover the cap. The coolant lever should between the
“max” and “min”.
5 Fill the coolant into the rear inlet slowly until there is no air coming out.
6 Start the engine at idle speed for several minutes, if there is air coming out and the coolant lever
goes down, fill some coolant again until no air and no lever-downing, cover the cap.