-DSP
Set DSP
First – F
W
phone would use
Signal S
VA
-CALL
Yo
configuration as you desired
ifth Codec: Set the priority level of codecs
hen you make a call, the phone would use set first codec to match the other party. If fail or not found, the
second codec to match, etc.
tandard: Choose the signal standard according to your needs or preferance
D: Science detection. If activate, G.729 Payload Length maximum is 20ms
SERVICE
u could configure relevant call service here
u pick up the phone. You could
p automatically if
you could just dial #23 to call
ject every incoming call
Call Service Setting
Hot Line: Configure hot line number. If configured, the phone would dial out the set number once yo
not dial other numbers if hot line number is set
No An er Time: Configure no answer time.While set, when there is an incoming call, the phone would hang u
w
nobody answers the call within the set time
P2P IP Prefix: Configure prefix for peer to peer call
For example, the IP you are calling to is 192.168.0.23. If you set 192.168.0 as P2P IP Prefix,
out
Do Not Disturb: Choose to activate do not disturb function. Under this mode, the phone would re
to receive phone call from) or delete black list here
Black List
: You could add black list (the number you don’t want
dd limit list (the number you don’t want the phone to dial out) or delete limit list here
set phone book through this web configuration
Limit List
: You could a
-PHONE BOOK
You could also
Phonebook Table
: Indicating the phone number information that you set