Smart Wireless Control ( EX : Power bank / Lamp / Fan... ) ON / OFF
Display in : Meter Mode / Timer Mode
/ Power Meter
Satting for :
Count Down Timer /
Over Current Setting /
Low Current Limit & Time Offset
Real - Time Count Down Time in
HH:MM:SS format
App Icon Notations
Count Down Timer Set - Time in
HH : MM : SS format
Timer ON/OFF
Factory Default ( 6 hours )
Count Down Timer
( Set - Time in HH : MM : SS format )
EX : Connect the device for more
than 1 hour , is power off
Low Current Limit & Time Offset
( Avoid overcharging )
EX : When a low current is less
than 0.05A , continuously
over 20 minutes is power off
Over Current Setting
( Over load protection )
EX : Connect the device for more
than5.0A , is power off
App Description (
for advanced control
)
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device , pursuant to Part 15 of the FCC Rules .
These limits are designed to provide reasonable protection against harmful interference in a residential installation .
This equipment generates , uses and can radiate radio frequency energy and , if not installed and used in accordance with the instructions ,
may cause harmful interference to radio communications . However , there is no guarantee that interference will not occur in a particular installation .
If this equipment does cause harmful interference to radio or television reception , which can be determined by turning the equipment off and on ,
the user is encouraged to try to correct the interference by one of the following measures :
. Reorient or relocate the receiving antenna .
. Increase the separation between the equipment and receiver .
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
. Consult the dealer or an experienced radio / TV technician for help .
FCC Caution :
To assure continued compliance , any changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to operate this equipment.
( Example - use only shielded interface cables when connecting to computer or peripheral devices ) .
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter .
than 4.0A , is power off
This device complies with Part 15 of the FCC Rules .
Operation is subject to the following two conditions :
( 1 ) This device may not cause harmful interference , and
( 2 ) This device must accept any interference received ,
including interference that may cause undesired operation .
-R\ELHQ7HFKQRORJLHV&R/WGKWWSZZZMR\ELHQFRP
FCC ID : UVXGC101001
