Joy Sport Life Fit, Руководство пользователя

Страница: 13 / 34

3. Clean Please eliminate the dust regularly after a period of use, to keep the power
panel and the head of the sensor clean.
4. Evaluation of friction The friction between running belt and board will be
increased as dust or reduced lubrication, this perhaps can harm motor, controller
increased friction is with following character:
(1) When shut off power of treadmill, the running belt can‟t be moved or it‟s difficult
for user to move by foot.
(2) Causing harm of motor of controller, open circuit and the fuse blows.
5.Adjust slanted running belt
All running belt are adjusted before the treadmill leaving the factory, but after a
period of time of using, the belt will become slanting, it may caused by the following
reasons:
(1) The engine frame is not steady.
(2) The user‟s feet are not in the middle of the running belts when they are using it.
(3) The force on the feet is not even. If the running belt is slanted by the user, it can
return to normal after running without anyone for a few minutes. If the running belt
can not return to normal by itself, we can adjust the running belt regulator with the
inner hexagon spanner
, adjust it semicycle once. If the running belt is near the left
side, adjust the left bolt clockwise or adjust the right bolt counter clockwise.(look at
picture a) If the running belt is near the right side, adjust the right bolt clockwise or
adjust the left bolt counter clockwise.(look at picture b)
6.Adjust flab or tight belt
After a period of using, the running belt will become a little longer and give us some
feeling of stopping when we are running. When this kind of phenomenon appears,
adjust the running belt adjustable bolts clockwise and make the two sides equable,
adjust them semicycle once.(look at picture c).Continue to do this until the running
belt is not skided or slanted. The adjustment should not exceed 2---3circles every
time, and it should not too tight , avoiding the running belt damaged permanently.