Joy Sport CT-Unicum, Руководство пользователя, Страница: 60 / 64

Joy Sport CT-Unicum
Roller Adjustment
After the machine is completely assembled, if any of the PU rollers occur too close to the alum rail
due to screw size & holes tolerance during the assembly, you may adjust the rollers with the following
procedures:
Photo 1
STEP1
As shown in Photo 1 and Drawing 1, release,
two screws & take off the roller cover. As the left
and right pedals are different, you will find two
different Roller Assemblies, style A and B, as
shown in the drawing. There are three nuts in
each style A and B assembly as marked in the
drawing
➀ 、 ➁ 、 ➂
for each nut.
STEP2 Photo 2
As shown in Drawing and Photo 2, use the tool
( *2 wrench ) to slightly loosen nut
➀
for both style A and B pedals, roughly 4 ‐ 5 turns .
STEP3
Determine the direction you desire to move the
rollers. ( As shown in Drawing (3A)/(3B)/Photo 3)
(A) If you would like to move the roller closer
to nut (2), loosen nut (3) for 4~5 turns.
Turn the center axle to move the roller into the
new position then use two tools ( *2 wrench ) to
tighten up nuts (1) & (3) firmly as shown in Photo 4.
(B)If you wish to move the roller closer to nut (3),
loosen nut (2) for 4~5 turns, then turn the center axle
to move the roller into the new position. then
use two tools ( *2wrench ) to tighten up nuts (1) & (3)
firmly as shown in Photo 4.
After roller adjustments are completed, reattach the roller
covers with the two screws ( released from Step 1 ).
3A
3B
Photo 3
Photo 4
JOYSPORT
www.joysport.nl
27